Discussie forum over overige software. Voor vragen, specificaties, ervaringen etc..
Door weerstationhoogeloon
#67704
Louis, die polygoon kun je zelf instellen onder menu-item "Map User Accounts"-> en dan in het kaartje een aantal punten plaatsen en zodanig zetten als dat je denkt dat dit het gebied is waarvoor je weer-metingen representatief zijn.

"Once you are satisfied your Fire Weather Station is located correctly on the map, zoom into Level 8 or above. If you left click on the map you can place a series of points (up to 10 max) surrounding your station in a polygon. This area should denote the effective climatic & vegetation zone your station fire weather data encompasses (it is limited to 1000 square kilometres, 386² miles, areas greater than this amount will be ignored). These points are draggable, or you can click on them to remove them."

daarna op Update drukken en instelling is gereed.

gr. Remie