Discussie forum over weatherlink software. Voor vragen, specificaties, ervaringen etc..

Door Prinsen
#61344
's Avonds sluit ik weatherlink om 20.00 uur even af om de gegevens met WX Data op te halen. Daarna start ik weatherlink weer op. Maar sinds de nieuwe computer (windows 7)kan hij dan de poort niet weer terug vinden. Wel als ik de usb poort er even uit haal en weer in stop of als ik de computer opnieuw opstart. Een probleem! Wie weet een oplossing. Heb ook al een nieuwe driver geïnstalleerd voor windows 7.
Door JozBaz
#61350
Heb je onderstaande stappen al geprobeerd?
Op het moment dat hij de poort niet kan vinden, 'ziet' je computer dan nog wel het USBXpress apparaat?
Ook zou ik eens kijken in de BIOS van je nieuwe PC. Zitten daar wellicht 'USB power save' opties die je uit kunt schakelen?

Succes.

Troubleshooting USB Communication
• Close the WeatherLink software.
• Disconnect the USB cable from the console or Envoy.
• Plug the cable back into the console or Envoy.
• Open the WeatherLink software again.
• Open the Communications Port dialog box. Select USB if USB is not
selected in the communications field and follow the prompts.
• Click Test to verify communication between the station and the software.
If the test is unsuccessful, either the station is malfunctioning or the drivers for communicating with USB have not been installed successfully. To verify that the driver is installed, look in Windows’ System Properties -> Device Manager -> Universal Serial Bus Controllers and see if the
USBXpress Device is listed. If the driver is listed and there is still no com- munication between the station and the computer, call Technical Support. If the drivers are not listed, contact Technical Support for instructions on installing the necessary drivers.
• If you are using a third party application that requires the USB connection to emulate a COM port connection, see WeatherLink Online Help for more information or Contact Technical Support.
Door baroman
#61351
Hallo Ans

Wat ik doe met Weatherkink deze file kopier ik naar een usb-stick, vanuit Wx-Data selecteer je de usb-stick en de file wie je wil importeren dan hoef je Weatherlink niet af te sluiten om je gegevens te importeren.

Groeten Ronnie..
Door Prinsen
#61367
Jammer dat het hele verhaal in het Engels is. Ik begrijp er wel veel van maar niet alles. Tot en met click Test heb ik al gedaan. Unsuccessful. Ik ben geholpen om een andere driver te intstalleren. (Iemand waar ik de computer gekocht heb) Ik zal dit verhaal nog met hem doornemen. Wie weet??? Bedankt voor de reactie!
gr. Ans
Door Prinsen
#61368
Zijn ook extra dingen die je doen moet. Ik sluit de computer nu even af en 2 minuten later is hij weer opgestart. Maar ik wil het zonder opnieuw opstarten doen.
Verder werkt het prima. Bedankt voor de reactie. Gr. Ans