hulstein schrijft:
Bedankt, de informatie was duidelijk, en ik heb het volgende gevonden : het gaat fout vanaf 22 oktober rond 20:00 tot ca. 21:30 uur. (zie afb.)
Nu blijft voor mij de vraag nog over, hoe wijzig ik al deze gegevens.???
ben hulstein ....
1. Selecteer een datm tijd veld (20131022190000) met de eerste afwijkende waarde
2. plak dat in het veld van
3. zet als test 60 in het veld +secondes
Druk dan op wis.
Bij alle metingen die in de periode vallen komt een *
dit is de tekst uit de manual
http://www.meteohub.de/files/meteohub-v4.7en.pdf
(versie 4.7 maar nog steeds van toepassing):[size=2]The number at the beginning of each line is the UTC time stamp. Format is YYYYMMDDhhmmss (year, month, days, hour, minute, second). Next is the unique id that identifies the sensor followed by sensor specific data as described in appendix C.
Beside displaying raw data this page also allows for deletion and undeletion of raw data. This might be necessary when your sensors have caught faulty data and you want to get rid of these. For cumulative data like the total rainfall, Meteohub notices the increase of total rain during the deleted period and subtracts this from further computations. This comes handy, when you have false rainfall readings because you are cleaning the rain sensor with water and thereby the sensor registers rainfall. By deleting these data records you also get rid of the false rainfall the sensor has given to Meteohub by an increase of total rainfall value. Deletion is done by giving the records a mark (* at the end). This allows to undelete records later on, when you decide so.
When pressing the "delete" button Meteohub deletes data with the time stamp specified in the "from" field. In the "seconds" field on the right of the "from" field you can specify the size of the time frame. A positive number in seconds will delete data up to the point in time ahead of the given time stamp. A negative number of seconds will delete data starting from time stamp minus these number of seconds until reaching the time stamp.
Example: When you put "20080523165651" in the "from" field and give "+70" into the "seconds" field, then raw data from 23.5.2008 16:56:51 to 16:58:01 will be deleted when pressing the "delete" button (see example). When you input "20080119003000" and "-30" all raw data from 23.5.2008 16:56:51 to 16:58:01 will be deleted. If you don't specify any seconds only data matching exactly the time stamp will be deleted. If no filter has been specified, deletion will be done for all sensor data. If a filter is defined, only data for selected sensors will be deleted. Undelete works exactly the same but removes the deletion mark from the records. Please notice that you can only delete, undelete and display data of the selected month.
To delete raw data the data logging process has to be halted before (see chapter 2.7 on this).[/size]
Let op de zin die ik rood gemaakt heb. Je moet het loggen wel stoppen, de deletes uitvoeren, en het loggen weer starten.
Op de beginpagina verschijnt dan onderaan by process
Weerdata Herberekenen: ?????iets van waiting of busy o.i.d.
Nadat de hercalculatie afgerond is
Weerdata Herberekenen: voltooid
Dan zijn die records verdwenen.
Ze blijven wel staan maar met een * er achter.
Het is lang geleden dat ik het heb moeten doen, maar zo moet het werken,
Wim