Discussie forum over Virtual Weather Station (VWS) software. Voor vragen, specificaties, ervaringen etc..

Door jeroenzwart
#36792
Door veelvuldige storingen aan mijn weerstation afgelopen week, is de maandhoeveelheid aan neerslag in het overzichtskaartje niet meer correct. Er staat nu 11 mm, maar dit zou 20 mm moeten zijn. Weet iemand hoe ik het juiste getal aan HetWeerActueel kan doorgeven, ofwel hoe ik dat in VWS kan wijzigen? Ik heb het jaartotaal (totalrain) aangepast en dit verschijnt nu ook correct. Ik heb de dagtotalen aangepast, maar het maandtotaal blijft ongewijzigd. Als je het maandtotaal probeert te wijzigen dan accepteerd VWS dat niet, blijkbaar omdat de maand nog bezig is (de huidige dag kan ik ook niet wijzigen, wel een dag later). Blijkbaar kan ik volgende maand het totaal wel wijzigen, maar dat is de bekende mosterd... Weet iemand hoe ik het wel kan wijzigen? Alvast bedankt voor de reacties.

Groet, Jeroen
Door Oebele
#36801
De volgorde is ook belangrijk dag->maand->jaar soms moet je dit een paar keer
herhalen dit heeft te maken met de vernieuwings freqentie van de bestanden.

Ook is het belangrijk dat de data in het weerstation wordt aangepast anders komen
de gegevens steeds weer terug.
Door ws vreewijk
#36811
Beste Jeroen,
Hier vind je veel nuttige tips.
http://ambientweather.wikispaces.com/Vi ... er+Station


kijk eens naar dit: specifiek over jouw probleem.

Problem
How do I change the daily, monthly or yearly rainfall totals in Virtual Weather Station?
?Solution
1.The daily, monthly and yearly rain totals are either calculated from your weather station or from Virtual Weather Station, depending on the type of weather station. If your station calculates these values, enter them directly in the console. If your station does not calculate these values, proceed to step 2.
2.Select Settings | Rainfall from the Virtual Weather Station menubar. Enter the appropriate values for daily, montly and yearly rain. If you receive the message Rain Exceeds Total Rain. To correct problem, enter an offset of equal or greater value in the Total Rain Field... , proceed to step 3.
3.The daily, monthly and yearly rain are calculated from the total rain. For example, the daily rain is calculated by subtracting the minimum total rain for the day from the maximum total rain for the day (or the difference in total rain for the day). If the daily, monthly or yearly rain exceeds the total rain for the day, Virtual Weather Station can not calculate these values. If your console allows you to change the total rain, enter this new value in the console (for example, enter a value equal to or greater then the yearly rain total). If your console can not be adjusted, change the total rain offset as described in step 4.
4.To change the total rainfall from Virtual Weather Station, select Settings | Calibration from the menubar and enter a bias in the total rain. For example, if the console total rain value is 10.00 inches, and you would like to change the total rainfall to 30.00 inches, enter an offset of 20.00 inches in this field. This change will have an immediate effect on the daily, montly and yearly rainfall totals. To correct these values, repeat step 2.


Mvr gr Chris
Door jeroenzwart
#36836
Oebele en Chris,

Bedankt voor de tips. Ik had één en ander al uitgeprobeerd, maar op één of andere manier accepteerd VWS dit niet: die komt steeds met de melding dat de ingevoerde totalrain groter is dan de totalrain volgens de Envoy, ondanks het feit dat ik deze met voldoende offset heb verhoogd... In de Envoy kan ik totalrain ook niet wijzigen. Deze springt dan vervolgens naar andere waarden, waardoor de problemen alleen nog maar groter worden... Dus als jullie suggesties hebben?

Jeroen